- Make sure this fits by entering your model number.
- Output 54.6V 1.5A, World Wide Input Voltage 100-240VAC 50/60Hz
- 105℃ Output capacitor, global applicable AC Input voltage.100% full load aging test, Internal EMI filter, ripple minimum. The precision current between ±0.1A, the voltage tolerance is ±0.1V, absolutely not virtual marking.
- The charger Built-in simply fan, with radiating fin surrounding the board, dissipating the heat through the shell, So some hot on the shell when charging is very normal, but it is durable.
- The Charger protected: Short circuit protection/ over current protection/ over voltage protection; red light — charging, green light — charge OK, it stop automatically when the battery is full.
- Replace your broken charger or add an extra charger to charge in 2 locations without taking the original charger with you
Brand Name: Tangspower
Protections: Short circuit / Overload / Over voltage
LED Display: Red: In charging state, Green: Full Charged
Use: lithium battery pack charger
Input Voltage: 100-240 V 50/60 HZ
Suitable Voltage / Frequency: 90-264 V 47 / 63Hz
Output Voltage: 54.6 V
Output current: 1.5A
Power: 81.9 W
Productivity: 80%
Fluctuation / Noise: <100MV
Working temperature: 0-40 ° C
Storage Temperature: -20-85 ° C
Working Nemi: 5% ~ 90% RH
Storage Humidity li ion battery charger: 5% ~ 90% RH
Plug type: American
Connector: DC
Housing material: PC
Characteristic: short-circuit / over-protection
Note : the charger connector size is 12MM, no 8MM. Please confirm what you need.
Use and maintenance of the charger :
1. When charging, first connector to the battery, then connect to AC; after full, cut off AC,
then pull the battery plug. If you pull the battery plug first while charging, especially when
the charging current is large (red light), it is very easy to damage the charger.
2. LED display after turning green, then charge for 2-3 hours.
3. Please do not run out of battery power, then charger. Otherwise the battery cannot be
protected or even damaged.
4. long-term shallow discharge battery, about 3 months, for a deep discharge, is the so-
called re-lighting, which is conducive to the activation of long-term immobile material in
the deep part of the battery. Luminous means that riding the controller battery
undervoltage protection action
5. do not use the battery for a long time, you must charge once (2-3 months).
6.Please use the charger in a dry place in time.
7.When you do not use the charger, do not always connect the power supply.
8.Please confirm your battery, Because it is used to charge the lithium battery. Do not
use the charger on the LiFepo4 battery, otherwise the charger will be got incredibly hot.